Soundboard key hanger

By Byteworks

Sound-board-style key holder panel: seven real-size 1/4 in jack sockets in two staggered rows, four mixer knobs with scale arcs, a slotted speaker grille across the top, an LED meter row and an engraved spectrum-analyser bar graph along the bottom. Six plugs sit fully inserted and the seventh is pulled out for display.

Model
stl3mfstepobjglbbrep
Customize for free
Soundboard key hanger, 3D printable model

Prompt that made this

Key hanger with sound jack sockets and male inputs (all real sizes and shapes) with keyring holes to imitate a sound board

Open the model

Made in Voloom from the prompt under the model. Sign in to download the STL, or fork it so every size on the right becomes editable — without spending credits.

Why this one

A decorative key holder panel for the home, for audio fans, musicians and sound engineers, styled like a mixing desk / sound board.

The panel screws to a wall with the jack face outward. Each key goes on a keyring through the eyelet at the end of a male 1/4 in jack plug. The plug's TRS-style shaft slides its full length into a real-size 1/4 in socket, stopped by the barrel on the hex nut. Pulling the plug out frees the keys. One plug is shown pulled out as a showcase. The knobs with scale arcs, speaker grille, LED row and spectrum bars are decoration that make it read as a sound board.

How to print

Download the STL, 3MF, or STEP and slice it. Fork the design to change a size before you print.

More to make

  • Multiboard bit holder, 3D printable modelModelFork

    multiboard bit holder

    Multiboard bit holder

    Multiboard bit holder as a parametric solid. Change a size, then download the STL.

  • Door stop wedge, 3D printable modelModelFork

    Community

    Door stop wedge

    A 130 x 45 mm door stop wedge rising from 3 mm to 28 mm, with triangular grip ridges on the slope, a lanyard hole near the tall end and a slightly dished und…

  • Opengrid pen cup, 3D printable modelModelFork

    opengrid cup

    openGrid pen cup

    openGrid pen cup as a parametric solid. Change a size, then download the STL.

  • IKEA Skådis screwdriver holder, 3D printable modelModelFork

    Community

    IKEA Skådis screwdriver holder

    Two-piece IKEA Skådis screwdriver holder for printing, now stood upright as it hangs: a vertical back plate with four rounded J-pegs and two swept supports f…

  • HSW bin 3x3, 3D printable modelModelFork

    honeycomb storage wall bin

    Honeycomb Storage Wall bin

    A bin that pushes straight into your honeycomb wall on hex plugs, with a curved front you can reach into.

  • Dry box hygrometer mount, 3D printable modelModelFork

    Community

    Dry box hygrometer mount

    Dry-box hygrometer bezel: 50 mm ring, 8 mm deep, for a 45 mm face, with a 2 mm gasket flange and a separate knurled retaining nut.